Features

A professional chemical anchor for effective mounting and securing of all building materials, including concrete, solid and hollow stone and aerated concrete,… .

Anchor can also be used as a filler for superfluous drill holes,... .

• Two-component chemical anchor based on vinyl ester resins.
• Withstands high forces.
• Can be used on wet surfaces - even under water.
• Can be applied at temperatures from -5°C to +40°C.
• After rapid hardening, becomes stronger than the underlying material:
  • Hardens without shrinkage, making it reliable.
  • Hardens without expansion, making it stress-free.
• Safe, environmentally friendly and easy to use. Also suitable for use indoors: Styrene-free, phthalate-free and has little odour.
• Extremely high UV and chemical resistance.
• Can be used in aggressive surroundings.
• Highly resistant to chlorinated and salt water.
• High dimensional stability: Can be used over your head in holes in the ceiling.
• Very long storage life, even when the cartridge has been opened and used.

Why use Anchor?

Anchor is a two-component resin cement based on styrene-free vinyl esters and a standard pattern. Can be injected using a Tec Gun. The two components are mixed using static mixer tips.

The unique combination of rapid hardening, wide margins for application and physical properties make it a unique chemical anchor for the professional market:

• Mounting and assembly of structural components in all building materials, including uncracked concrete, light concrete, foamed concrete, solid masonry, solid and hollow bricks, natural stone (important: test stone for discolouration).
• Anchoring of, e.g., railings, sanitary fixtures, cable ducts and pipes, metal sections, reinforcing steel, internal threaded rods, threaded rods, façade panels,… .
• Anchor can also be used as a repair cement for concrete: As a filler for superfluous drill holes.
• Can, thanks to its expansion-free hardening, be used for anchors where there is limited space between the shaft and wall.
• The cartridge can be reclosed with the protective cap after use and stored.

Instructions

• Drill a hole of the correct diameter (see diagram).
• Remove dust from the drill hole with a brush, pump or compressed air.
• Place Anchor/ 2K Mix in an adapted Tec Gun and attach the mixer tip.
• First expel about 10 cm to get a correct mix of the two components.

a. For solid masonry: Fill the drill hole from bottom to top.

b. For hollow masonry: Use a Harpoon plug and fill this with Anchor.

• Insert the threaded rod using a turning motion.
• Remove excess product.
• Visual check.

Anchor can be used at freezing temperatures down to -5°C. As long as the cartridge remains at room temperature.